3D Printed Dewalt 20v Battery adapter for Power Wheels style vehicles. Each harness allows you to plug your 20v battery right into the plug on the vehicle.
 
You will receive 1- 12gauge wire harness with 2 spare 40amp fuses included.
 
** Be sure to research any additional mods needed to run 20v on your vehicle. We are not responsible for any damage for running a higher voltage. **
 
** It is important to take note of your battery charge level. There is no intelligence to this setup and is possible to run the battery level to low. **
 
Only the 3D printed adapter harness.
 
The battery locks in just as if it were mounting to a tool. Depress the release tabs on the battery, and it slides right out. Each bracket has (2) 5mm holes to allow screws/bolts to be used for mounting to the surface (screws/bolts not included). It is best to mark and pre-drill the holes before final mounting. Without doing so, can cause the arms to slide inward slightly making it difficult to smoothly slide the battery on/off.
 
Mounts are printed in Black ASA material and will hold up strong in an indoor and outdoor environment.
 
These are 3D printed in house and made to order. These take several hours to create so please factor in a day or two for order processing. Each print will also have our logo embossed.